This page contains a series of images of custom and special loggers, without details or specifications.
Kooltrak is asked from time to time to manufacture a variety of modified logger housings to suit particular applications, and some of these parts are shown here. The availability of any particular part is subject to individual discussion, and please note that there might be a requirement to purchase a considerable number of special parts before Kooltrak can undertake to supply them.
In general the type of cable used on network loggers can be changed, and might be thin, thick or armoured. We emphasize that it is uneconomic for everyone involved to manufacture small numbers of custom parts, and these devices are presented primiraly as a source of ideas.
Our apologies that some of the photographs are of marginal quality.
|
|
This is a network logger in a 10mm diameter aluminium tube housing.
Intended use is to be inserted in an access tube into the target area. |
|
|
|
Network logger in a 12mm diameter stainless steel tube housing.
Intended use is to be inserted in an access tube into the target area.
Rugged housing for tough environments, armoured cable. |
|
|
|
Network logger in a 20mm diameter stainless steel housing only 3mm thick.
Thin and somewhat fragile cable. Intended for semi-permanent insertion into
moulds and other places with very limited thickness possibilities. |
|
|
|
This network logger housed in plastic moulding with relatively thin cable.
Intended use is for casting in place in thermo-curing compounds for example concrete.
Logger can't be recovered after use and is left in place. |
|
|
|
This network logger is as rugged as we can make it and has an armoured cable.
Intended use is in seawater tanks with aggresive inhabitants eg prawns or lobsters. |
|
|
|
This network logger has a stainless steel housing with a pipe thread and an
armoured cable. Intended use is to be fitted in pipes and tanks in the chemical
or dairy industries. Can be fitted with a contact box or wired into a network. |
